Hardware and Functional Specifications

MicroPeckerX Hardware Specifications

Item	Specification
Power Supply	USB Bus Power (5 V, 300 mA)
Dimensions	65 (W) x 35 (D) x 16 (H) mm
Weight	45 g
LED	4 LEDs Orange: Power status (lit when powered) Green: Communication Ch1 (blinks during LIN communication on Ch1) Yellow: Communication Ch2 (blinks during DIO/AD communication on Ch2) Red: Error (lit when an abnormal condition occurs)
Synchronization Interface	2 ports
DIO/AD Interface	1ch DIO 9-pin (up to 4 DIO points and 1 A/D point can be monitored)
DIO Port Voltage	Input: 3.3 V to 5 V, Output: 3.3 V
A/D Monitorable Voltage Range	0 V to 5.5 V / 16.5 V / 45 V
Hardware Protection	Equipped with ESD / reverse connection / overcurrent protection circuits
USB Ports	2 USB Micro-B ports (Main, Sub)

CE marking acquired
EMI: EN55011(2020) Group1 ClassB
EMS: EN61000-4-2(2009), EN61000-4-3(2010)
FCC compliant
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.

Do not use the Sub USB port.

Item	Specification
Signals	LIN, VBAT, GND *Clip connector used
Cable Length	Total length: 0.3 m
Shield	None

Item	Specification
Cable Length	Total length: 25 cm
Shield	None

*The sync cable is not used in this system.

Item		Description
DIO (Digital I/O)	Number of Channels	4 channels (independent setting per channel)
	I/O Direction Setting	Each channel can be switched between Input and Output
	Pull-up Setting (Input)	Selectable from Pull-up / Pull-down / None
	Output Level Setting	Hi / Lo selectable
	Output Mode	Switchable between Open Drain / Push-Pull
	I/O Voltage	0 to 3.3 V
	Monitoring Cycle	Configurable from 1 ms to 60000 ms
	Label Filter	Lo / Hi / Lo->Hi / Hi->Lo / wildcard conditions available
	Log Output Destination	File and on-screen (up to 100,000 records)
	Log Format	Text (CSV), outputs A/D conversion data (*physical value conversion planned in future)
	Log Split Output	No split, file size (1 MB to 4095 MB), records (100 to 2.5 million lines), timer (1 sec to 3600 sec)
	Log Trigger Mode	Free RUN, start trigger, stop trigger
	Log Trigger Conditions	Specified data reception, key input
AD (Analog Input)	Sampling Frequency	1 Hz to 10 kHz (configurable in 1 Hz units)
	Sampling Period	0.1 ms to 1000 ms
	Number of Channels	1 channel
	Input Range	Lower limit: 0 V, Upper limit selectable from 5 V, 15 V, 40 V
	Resolution	12 bit
	Accuracy (DC Voltage)	+-17.5 mV
	Noise Immunity	No filter
	Monitor Data Format	A/D conversion data (*physical value conversion planned in future)
	Log Output Destination	File and on-screen (up to 100,000 records)
	Log Format	Text (CSV), hexadecimal output
	Log Split Output	No split, file size (1 MB to 4095 MB), records (100 to 2.5 million lines), timer (1 sec to 3600 sec)