Skip to main content

Setup Guide

Thank you for purchasing a MicroPeckerX product.
This guide explains how to set up your product before use.

Setup Flow​

The overall setup process is shown below.

Setup by Product​

The table below shows which steps are required for each product.

ProductDownload
Software
Install
Software
Download
License File
Register
License
Add
Plugin
MicroPeckerX CAN FD Analyzer
(S810-MX-FD2)
OOOO-
MicroPeckerX Message Authentication Plugin
(S810-MX-PM1)
OOOOO
MicroPeckerX InstaGW
(S810-MX-GW2)
OOOO-
MicroPeckerX LIN Analyzer Plus
(S810-MX-LN1)
OOOO-
MicroPeckerX DIO/AD License
(S810-MX-DA1)
O
(*)
O
(*)
OO-
MicroPeckerX CAN FD Application Development Library for Windows
(S810-MX-ADL1N)
O----
MicroPeckerX CAN FD Application Development Library for Linux
(S810-MX-ADL1L)
O----
MicroPeckerX SocketCAN Driver
(S810-MX-SKTCD)
O----

*: Not required if MicroPeckerX Control Software is already installed.

Application Setup​

Install the MicroPeckerX product application on your PC.

1. Download Software​

Download the software (or plugin) from the "Product Downloads" page on the Sunny Giken website.
For details, see Download Software.

2. Install Software​

Run the downloaded installer and install the software.
For details, see Install Software.

License Registration​

If this is your first use after purchase, you must register a license to the MicroPeckerX device to enable product features.

3. Download License File​

Issue and download a license file from the "MicroPeckerX License File Issuance" page on the Sunny Giken website.
For details, see Download License File.

4. Register License​

Start the License Manager tool and register the downloaded license file to the MicroPeckerX device.
For details, see Register License.

Plugin Installation​

If you want to add a plugin to the product application, follow the step below.

5. Add Plugin​

Start the Plugin Manager tool and add the downloaded plugin to MicroPeckerX Control Software.
For details, see Add Plugin.